Guangzhou Wonderfu Automotive Equipment Co., Ltd
Guangzhou Wonderfu Automotive Equipment Co., Ltd
Add to Cart
Car Ultrasonic Cleaning Machines 4 Cylinder Fuel Injector Auto Tester And Cleaner Tool
Why have to clean injector?
* When we turned off the engine suddenly, the gasoline which have been spray out can not be recycled. It would attached on the injector and combustion chamber walls.
* Gasoline is easy to volatile, but wax and varnish were stayed.
* Heat these wax and varnish day after day,they will be changed into hard coke.
* The hard coke will be produced more quickly and more thickly when engine work with poor quality fuel.
Fuel Injector Tester is an instrument which can test & measure the injectors' droplet formation, atomization, efficiency and fuel delivery. All are visually and / or physically checked and tested as a starting point, rather than as a last resort. When problems are found, the injectors are cleaned in the supplied ultrasonic cleaning bath. The injectors mount in a special plate and are connected to the tester in order to operate them at high frequency during cleaning. After cleaning, the rubber sealing rings, plastic protection caps and filter baskets can be replaced (as applicable) before re-testing to ensure all the injectors are performing as a perfectly matched, balanced set.
Function:
| 1. Check the injector starting pressure, Assessment of the injector spray fog quality, Inspection of the injector spray oil range,the injector seal and angel and the injector oil flow |
| 2. The machine has fog dissipation convulsion device to improve the work condition. |
| 3. It has two grade filter to ensure the cleanliness of test. |
| 4. The parameter of common rail injector (fuel spray counts, frequency, pulse width, pressure etc.) can be set willfully. |
Features:
1. Cleaning hard coke from injector via ultrasonic and auto electronic technology;
2. Imitate working as vehicle's fuel system;
3. Backwashing;
4. Uniformity testing;
5. Fog detection;
6. Fuel injection quantity detector;
7. Tightness test;
8. Automatic cleaning mode;
9. Vehicle cleaning mode;
10. The minimum pulse width test.
Installation :
1. All equipment are delivered with 3 pin electrical cable, use the ground connection for equipment and operator protection.
2. Verify that test liquid level at 2.5L or at least between the range of two red lines. For a new machine, please fill 2.0~ 2.5L testing liquid. Never fill up the tank at its maximum capacity.
3. Fill up the ultrasonic cleaning tank with the liquid for injector cleaning. Liquid level should not reach 3 cm below the tank edge, in order to avoid liquid overflow on device. Take special care not to drop liquid on the equipment when filling up or emptying the tank.
